Connectors and adapters are available in different pin configurations with single wires as well as pin contacts. Front mounted sockets with wires can be positioned with a coupling nut. Sockets for rear housing assembly with different lenght pin contacts for soldering directly on the printed circuit board complete the program. An installation socket for direct assembly on the printed circuit board is also available with a shielded connection option in an axial and angled version. A spring-loaded shield plate connects the socket housing for the M12 Connectors dirctly to the printed circuit board. All products in this series are designed for a printed board thickness of 1,6mm and a device wall thickness of 2-3mm

1. Frontmounting, with wire, M16x1,5-thread
2. Frontmounting, with wire, positioning possible, M16x1,5-thread
3. Backmounting, with wire, M16x1,5-thread
4. Backmounting, dip-solder, M16x1,5-thread
5. Frontmounting, with wire, PG9-thread
6. Frontmounting, with wire, positioning possible, PG9-thread
7. Backmounting, with wire, PG9-thread
8. Backmounting, dip-solder, PG9-thread
9. Turnable coupling-nut - Frontmounting, with wire, M16x1,5-thread
10. Turnable coupling-nut - Frontmounting, with wire, M12x1-thread
11. Square End - Frontmounting, with wire, 20 and 26mm
12. Lead through for switch case
13. PCB - Frontmounting, axial, installation height 5,5 and 10mm
14. PCB - Backmounting, axial, installation height 5,5 and 10mm
15. PCB - Frontmounting, dip-solder, angled
16. PCB - Backmounting, dip-solder, angled
17. PCB - With shielded connection, backmounting, dip-solder
18. Panel Plugs

         - Soldering Version
         - Print Version